This is a NEW 10A RC TX Controlled Relay Switch PWM Receiver LED Control Spray Switch

Normal Mode:
The module can read a pulse width that can range from 400 to 2600us.
If the width of the pulse is more than 1800us, the MOSFET switch will close, if less than 1200us, the MOSFET switch will open.
Safe-protection Function:
This module has a safe-protection feature that reduces the likelihood of unexpected activation.
In the below 2 conditions the Safe-protection mode will active:
1. The pulse is more than 1800us at first power-up, the MOSFET switch open. The LED will blink, you should move the input to the off position, then normal more will active;
2. The signal is bad continuously for 500ms, the MOSFET switch open. The LED will blink. When the signal is good, the device will deactivate safe-protection mode.
LED:(Normal mode)
The LED will on when input pulse >1800us;
The LED will off when input pulse <1200us;
Safe-protection mode: the LED will fast blink.

10cm JR Male To JR Male Servo Extension Wire can be used with all servos and ESCs to extend the length of the stock cable. This cable is useful for building RC Cars, Planes, Boats, and Robotics Projects which use servos. This has both sides JR Male Connectors.

The high-performance 1555 2-blade Carbon Fiber CW/CCW Propeller was created especially for fans of T-Motors. These precisely constructed propellers will increase the effectiveness and power of your drone. They are made of tough carbon fiber for maximum performance and durability.

Achieving stable flight and fine control is simple with options for rotation in both the clockwise (CW) and counterclockwise (CCW) directions. Upgrade to the 1555 Carbon Fiber Propeller to elevate your T-Motor experience to new heights and enjoy the ideal marriage of innovation and excellence.

Key Points of Mixed Control Debugging:

l First make sure the forward and backward motors are in the same direction. (If a motor is turning incorrectly, exchange the +-stage wires behind the motor)

l Then adjust the direction, if it is not as expected, the remote control may be reversed, set it back

The Dual-mix ESC Has the Following Modes: 

l Mixed control mode (both throttle / steering mode): 2 or 3 channels (2 channels are recommended because 2 channels automatically return to center) to control the throttle, 1 channel (or 4 channels) to control speed difference steering, throttle ratio 100%, steering ratio 100%, steering priority. Suitable for: tank (in this mode, gun control can play tanks), 4-wheel drive trolley (apm can be installed)

l Two-way independent: it is equivalent to two independent ESCs (if you want to simulate a real tank, the white three wires on the input end are connected to the receiver throttle (3 channels), and the yellow single wire is connected to the receiver 2 channels)

l Two-way synchronization: In mixed control mode, do not connect a single yellow wire, so that the two-way motor output is consistent

This 20A Brushed Electronic Speed Controller is a small-sized ESC that can supply a current up to 20A by using a 2S lipo battery as an input. The ESC accepts a standard RC signal as input and offers functions as forward, reverse, and breaking. This ESC has high-quality silicone cables for the battery input and the motor output.